Ultra Dry 70
ULTRA DRY 70 is a premium water-base, penetrating sealer, breathable, natural look. Designed to provide maximum stain protection.
All natural stone (Limestone, Travertine, Marble, Granite, Quartz, Slate & Sandstone)
Terra Cotta, stucco, pavers, concrete, veneer, tiles and grout.
Recommended for Commercial and Residential interior and exterior surfaces
including high-traffic areas such as kitchen, bathrooms, patios and driveways.
DOT classification : Non regulated
Approximately 200 to 3000 sf (19-279 m2) per gallon depending on the porosity of surface.
Stir well prior to use.
Do not thin or dilute
Do not apply to surfaces with temperatures of <40 F (<4.4C) or >95 F (>35 C)
Test a small area and allow a 24 hour cure time to determine desired results.
– Clean and dry surface to be treated (allow approximately 48 hrs drying time depending on temperature)
– Depending on area, apply using sponge, paint roller brush, paint pad, cotton towel or low pressure sprayer.
– Wait 3 – 5 minutes and remove any unabsorbed sealer with a cotton towel.
NOTE: If second coat is needed, wait 10 – 15 minutes between coats.
After one hour, test by dropping water on surface. If water is absorbed, apply another coat.
Avoid heavy usage on horizontal surfaces for 24 hours
Use only in a well ventilated area.
Keep away from heat or open flames.
Avoid inhalation and prolonged contact with skin.
Gloves and eye protection should be worn at all times.
Store in an upright position.
See SDS for additional safety data and personal protection information.
Eye Contact: Immediately flush eyes with water for at least 15 minutes. Get medical attention if irritation persists.
If swallowed: Do not induce vomiting. Get medical attention.
Skin and clothing contact should be washed with soap & water. Get medical attention if irritation persists.
KEEP OUT OF REACH OF CHILDREN AND PETS