Enhancer 98 sealer and enhancer – quart size
Approximately 200 to 3000 sf (19-279 m2) per gallon depending on the porosity of surface.
Stir well prior to use.
Do not thin or dilute.
Do not apply to surfaces with temperatures of <40° F (<4.4° C) or >95° F (>35° C)
Test a small area and allow a 24 hour cure time to determine desired results.
– Clean and dry surface to be treated (allow approximately 24 hrs drying time depending on temperature)
– Depending on area, apply using low pressure sprayer, paint roller brush, paint pad or cotton towel.
– Wait 5 – 10 minutes and remove any unabsorbed sealer with a cotton towel.
If second coat is needed, wait 10 – 15 minutes between coats.
After one hour, test by dropping water on surface.
If water is absorbed, apply another coat.
Avoid heavy usage on horizontal surfaces for 24 hours
Causes skin irritation.
May cause allergic skin reaction.
Keep only in original container.
Avoid breathing spray.
Wash skin thoroughly after handling.
Do not let product freeze.
In case of fire: Use extinguishing powder, alcohol resistant foam or carbon dioxide to extinguish.
Toxic to aquatic life.
Use only outdoors or in a well-ventilated area.
Wear protective gloves/protective clothing/eye protection.
Contaminated work clothing should not be allowed out of the workplace.
Dispose of contents/container to an approved waste disposal plant.
IF INHALED: Remove person to fresh air and keep comfortable for breathing.
If symptoms occur, get medical advice/attention.
IF ON SKIN: Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes.
Get medical attention. Wash clothing before reuse.
Thoroughly clean shoes before reuse.
IF IN EYES: Flush eyes with plenty of water.
Get medical advice/attention.
IF SWALLOWED: DO NOT induce vomiting.
Get medical advice/attention if symptoms occur.Rinse mouth thoroughly with water.
KEEP OUT OF REACH OF CHILDREN AND PETS